National Instruments PXI-2530B - What You Need to Get Started

160-Pin Cable for the NI PXI-2530B Installation Instructions 2 ni.com
The following figure shows the 160-pin cable for the NI PXI-2530B.
Figure 1. 160-Pin Cable for the NI PXI-2530B
What You Need to Get Started
To use the cable, you need the following items:
❑ 160-pin cable for the NI PXI-2530B
❑ (Optional) Four NI TBX-50 screw terminal blocks
❑ NI PXI-2530B switch module and documentation
❑ #1 Phillips screwdriver
1 160-Pin Cable for the NI PXI-2530B Backshell
2 Cable Leg Labels
3 50-Pin Female D-SUB Connector Backshells
4Thumbscrews
NATIONAL INSTRUMENTS
NATIONAL INSTRUMENTS
NATIONAL INSTRUMENTS
NATIONAL INSTRUMENTS
NATIONAL INSTRUMENTS
1
4
2
3
60VDC/30VRMS CAT I ONLY60VDC/30VRMS CAT I ONLY
NATIONAL INSTRUMENTS
P1
P2
P3
P4