You can download all required software from ni.com/downloads.
When you install NI-DCPower, you need to install support only for the application software
that you intend to use. Access calibration support in the locations shown in the following table.
ADE Calibration Support Location
LabVIEW NI-DCPower Calibration palette
LabWindows/CVI NI-DCPower function panel (niDCPower.fp)
Related Documentation
You might find the following documents helpful as you perform the calibration procedure:
• NI PXIe-4112/4113 Getting Started Guide
• NI DC Power Supplies and SMUs Help
• NI PXIe-4113 Specifications
• NI-DCPower Readme
• LabVIEW Help
Visit ni.com/manuals for the latest versions of these documents.
Password
The default password for password-protected operations is NI.
Calibration Interval
Recommended calibration interval
2 years
Test Equipment
The following table lists the equipment NI recommends for the performance verification and
adjustment procedures. If the recommended equipment is not available, select a substitute
using the minimum requirements listed in the table.
2 | ni.com | NI PXIe-4113 Calibration Procedure
To Next Page
Loading...
Need help?
General
