My CMOS is corrupted. How do I set it back to default?
There are two methods that you can use to reset the CMOS.
First Method
1. Enter the BIOS setup program.
2.
Press <F9> to load BIOS defaults.
3.
Answer Y (Yes) to the verification prompt.
4.
Select Save and Exit Setup.
Second Method
1.
Power o the chassis.
2.
Remove the controller from the chassis.
3.
Press the Clear CMOS button (SW1) for 2 to 3 seconds as shown in the
following figure.
4. Reinstall the controller in the chassis.
© National Instruments
39
PXIe-8822/42/62 Getting Started
To Next Page
Loading...
