6. Hold the handle as you slowly slide the module into the chassis until the
handle catches on the injector/ejector rail.
7.
Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the PXIe-8822/42/62
should be even with the front panel of the chassis.
8. Tighten the four bracket-retaining screws on the top and bottom of the front
panel to secure the PXIe-8822/42/62 to the chassis.
9.
Check the installation.
10.
Connect the keyboard and mouse to the appropriate connectors.
11.
Connect the DisplayPort monitor video cable or adapter to the DisplayPort
connector.
12.
Connect devices to ports as required by your system configuration.
13.
Power on the display.
14.
Power on the chassis.
15.
Verify that the controller boots. If it does not boot, refer to the
Troubleshooting section.
The following figure shows a PXIe-8862 controller installed in the system
controller slot of an NI PXI Express chassis.
© National Instruments
5
PXIe-8822/42/62 Getting Started
To Next Page
Loading...
Need help?
General
