12 | ni.com | RMC-8357 Installation Guide
Installing the Outer Slides in the Rack
Install the outer slides in the rack as shown in Figure 6.
Figure 6. Installing Outer Slides in Rack
Installing the Chassis into the Rack
Push the inner slides, attached to the chassis, into the grooves of the outer slides in the rack and
slide the RMC-8357 into the rack, as shown in Figure 7.
Note The following figure shows an example controller that may differ from
your product.
1Nut (x6) 2 Outer Slide 3 Retaining Screw (x6)
2
3
1
To Next Page
Loading...
