© National Instruments | 2-33
RMX Programmable Power Supplies User Manual
CF21 Command Language Parameter
Selects the command language that is used in remote control messages. For the LAN interface
to function, this parameter must be set to "SCPi."
This parameter is applied when you turn the POWER switch off and on.
CF22 Emulation Parameter During Remote Control
Selects the emulation that is used during remote control. If you have set the command language
to legacy languages, you can only select “GEn” or “PAG.”
This parameter is applied when you turn the POWER switch off and on.
CF23 SCPI Communication Error Display Parameter
Selects whether to display communication errors. The errors are only displayed when you are
using the SCPI language.
Value Parameter Description
SCPi The SCPi language will be used (factory default setting).
LGCy Legacy languages will be used.
Value Parameter Description
nonE Remote control is performed using the RMX programmable
power supply’s commands made by National Instruments
(factory default setting).
5700 Remote control is performed using the N5700/N8700 commands
made by Agilent Technologies.
GEn Remote control is performed using the Genesys series commands
made by TDKLambda.
PAG Remote control is performed using the PAG series commands
made by Kikusui.
dCS Remote control is performed using the DCS series commands
made by Sorensen.
Value Parameter Description
oFF SCPI communication errors are not displayed (factory default
setting).
on SCPI communication errors are displayed.