© National Instruments 5 NI sbRIO-960x/962x/963x OEM Instructions & Specifications
Note Samtec SEAM connectors come in multiple heights, indicated in mm by the XX.X
portion of the following example part number: SEAM-40-XX.X-S-06-2. The height of the
mating connector you select to mate to the RMC connector determines the height of the
standoffs you need. Samtec, the connector manufacturer, requires that standoffs be
0.15 mm taller than the combined height of the RMC and mating connectors. Therefore, to
determine the required standoff height, you must add the heights of the connectors plus
0.15 mm. For example, if you are using a SEAM-40-03.0-S-06-2 connector to mate to the
RMC connector (SEAF-40-06.5-S-06-2), the required standoff height is 3.0 mm + 6.5 mm
+ 0.15 mm = 9.65 mm. Standoffs of this height are available from National Instruments
(NI 153166-12) or Samtec (SO-0965-03-02-L-N). Consult Samtec for alternative heights
and options. You must observe keepouts and maximum heights with all RMC and mating
connector combinations.
To Next Page
Loading...
