National Instruments SCB-68 User Guide

SCB-68 User Guide
68-Pin Shielded Desktop Connector Block
This guide describes how to connect and use the NI SCB-68 with 68-pin or
100-pin data acquisition (DAQ) devices and other NI products with a 68-pin
SCSI or VHDCI I/O connector. For a complete list of supported devices
and available SCB-68 features, refer to the KnowledgeBase document,
Compatible Devices and Cabling for the NI SCB-68 Terminal Block.
To access this document, go to
ni.com/info and enter the info code
scb68dev.
Figure 1 shows the SCB-68 connector block.
Figure 1. SCB-68 Parts Locator Diagram
Note
To use the SCB-68 with devices without analog input
functionality, you must change the default switch setting. Refer to
the Using the SCB-68 in Direct Feedthrough Mode section for more
information.
1 Quick Reference Label
2 Top Cover
3 68-Pin Connector
Screws
4 Lock Washers
5 Shielding Screws
6 68-Pin I/O Connector
7Base
8 Strain-Relief Screws
9 Strain-Relief Hardware
10 SCB-68 Board
Assembly
3
8
9
1 2
5
6
7
10
8
5
4

National Instruments SCB-68 Specifications

General

Brand	National Instruments
Model	SCB-68
Category	Cables and connectors
Language	English