National Instruments
™
, NI
™
, ni.com
™
, and SCXI
™
are trademarks of National Instruments Corporation. Product and company names mentioned herein
are trademarks or trade names of their respective companies. For patents covering National Instruments products, refer to the appropriate location:
Help»Patents in your software, the
patents.txt file on your CD, or ni.com/patents.
371199A-01 © 1995, 2002 National Instruments Corp. All rights reserved. January 2002
INSTALLATION GUIDE
SCXI -1353 SHIELDED CABLE ASSEMBLY
This guide describes how to install the National Instruments SCXI-1353
shielded cable assembly between a 100-pin E Series data acquisition
(DAQ) device and two SCXI modules. The SCXI-1353 consists of an
SH1006868 cable, an SCXI-1349 shielded cable adapter, and an
AI-48/DIO-24 adapter.
Introduction
The SCXI-1353 makes a low-noise, long-distance connection between
a 100-pin E Series DAQ device and two SCXI modules. The SH1006868
cable is available in lengths of 1, 2, 5, and 10 m. The SH1006868 cable
is Y-shaped, with a 100-pin male connector and two 68-pin female
connectors. One branch of the cable is labeled MIO-16, and the other
branch is labeled EXTENDED I/O.
The 100-pin connector of the cable attaches to a 100-pin E Series DAQ
device. The 68-pin connector on the MIO-16 branch of the cable attaches
to an SCXI-1349. The 68-pin connector on the EXTENDED I/O branch of
the cable attaches to an AI-48/DIO-24. The SCXI-1349 and AI-48/DIO-24
can attach to a variety of SCXI modules. Both these adapters have breakout
connectors that you can use to connect to other SCXI accessories, such as
the SCXI-1180 and the SCXI-1351.
What You Need to Get Started
To install and use the SCXI-1353, you need the following items:
❑ SCXI-1353 shielded cable assembly (included in this kit)
– SH1006868 cable
– SCXI-1349 shielded cable adapter
– AI-48/DIO-24 adapter
❑ SCXI chassis
™
To Next Page
Need help?
General
