Table 5. Single Host Ethernet Interface—Unmanaged Switch Configuration
Device Host IP Address Host Subnet Mask Device IP Address
NI USRP Device 0 192.168.10.1 255.255.255.0 192.168.10.2
NI USRP Device 1 192.168.10.1 255.255.255.0 192.168.10.3
Related Information
Setting Up the Network (Ethernet Only) on page 8
Using the Optional NI ExpressCard Slot - MXI Express
Interface Kit for USRP RIO to Connect to a Laptop
Computer
Laptop computers are not grounded, so you must complete the following steps to safely
connect a laptop computer to your NI USRP device:
Note The ExpressCard Interface Kit can be used only with NI 294x/295x devices.
1. Ensure the NI USRP device is plugged in and powered off.
2.
Touch the NI ExpressCard-8360B and outer metal case of the NI USRP device
simultaneously.
3. Connect the cable to the NI ExpressCard-8360B and NI USRP device.
4. Plug the NI ExpressCard-8360B into an available ExpressCard slot. If your laptop
computer is already running or hibernating when you install an NI ExpressCard-8360B,
you must restart to detect the NI USRP device. Otherwise, the NI USRP device is
detected when you start your computer.
12
| ni.com | NI USRP-29xx Getting Started Guide
To Next Page
Loading...
