▪
free:
This effectively turns host and preset synchronization off. The Metronome can
run freely at the tempo you set, independent of the preset loaded or the host’s tempo.
It is still setting the clock for all synchronized effects in the rack, and the current
tempo is still saved with the preset!
▪
The MUTE button and the VOLUME knob serve to adjust the volume of the Metronome
sound or to mute it.
5.5 Preset Volume
The Preset Volume Rack Tool
The
sound of many of GUITAR RIG’s components is highly sensitive to the level of their
input signal and their volume setting. This is commonly used for the sake of sound design,
resulting in volume differences between presets. Therefore, you might want to adjust the
overall volume of your Rack to achieve the same Output Level for different presets.
This is exactly what the Preset Volume does: simply adjust the volume fader after you have
found the sound you were looking for — its position is automatically saved with your pre-
set.
▪
Use the LEARN button to automatically set the optimum Preset Volume: After clicking
on it, just play loudly for a short while until the volume is automatically adjusted.
▪
The PRE Button allows you to hear Dry / Wet mixing before audio goes into the rack. In
default mode mixing is done after the rack and before the Master FX.
▪
Use the DRY slider to control the volume level of the dry signal.
▪
Use the MIX crossfader to switch between the Dry signal and the Wet (affected) signal.
▪
Use the WET slider to control the volume level of the wet signal.
The Rack Tools
Preset Volume
GUITAR RIG 5 - Application Reference - 46
To Next Page
Loading...
Need help?
General
