7. Press the Cue button B below the CUE MIX knob.
The button lights up, indicating that Deck B is now sent to the Cue channel, which you now
hear in the headphones. Note that now, no matter where you move the crossfader, you will still
hear Deck B, because its cue is on.
1. Press Cue button B again to toggle it off and press Cue button A.
You will now hear the track playing on Deck A, no matter what position the crossfader is in.
This is due to the fact that Deck A's Cue button is on, and the CUE MIX knob is still in the
center position.
1. Press both Cue buttons A and B so that they are both active (illuminated).
2. Turn the CUE MIX knob all the way to the left.
3. Now toggle the two Cue buttons on and off. Notice that when both Cue buttons are off
(unilluminated), there is no signal at all coming through the headphones.
4. Press both Cue buttons so that they are off.
5. Turn the CUE MIX knob all the way to the right. If the channel faders are up you will be
able to hear the main mix coming through your headphones.
Notice that when both channel faders are down, there is no signal at all coming through
the headphones.
6. Move the crossfader from one side to the other to hear the main mix in the headphone
cue.
Remember that no matter what mix you are hearing in your headphones, the main mix is
still controlled by the crossfader and channel faders.
4.1.4 FILTER | FX Modes
TRAKTOR KONTROL Z1's FILTER | FX knobs have a dual function in TRAKTOR DJ. The first is
standard control of the filter; the second controls the selected effect. This dual function oper-
ates through the use of the MODE button.
Using the Z1 with TRAKTOR DJ
Key Z1 Functions Using TRAKTOR DJ
TRAKTOR KONTROL Z1 - Manual - 17
To Next Page
Loading...
Need help?
General
