What to do if Nautel Transmitter shows 'Controller: SWR Shutback'?
If the Nautel Transmitter controller displays an 'SWR Shutback' error, which is often due to a transient SWR condition like an arc or lightning in the output transmission line or antenna system, try pressing the Reset button to clear the latched condition. Also, inspect the output transmission line for any punctures or damage.
What causes 'Module #: PS 1 (or 2) AC Fail' in Nautel NV30 and how to fix it?
The 'Module #: PS 1 (or 2) AC Fail' error in your Nautel Transmitter indicates that one of the two module power supplies is reporting an AC failure because its AC input voltage is less than 175 V AC. To resolve this, check the AC voltage applied to the power supply module that is reporting the error.
General| Power Output | 30 kW |
|---|---|
| Modulation Types | FM |
| Efficiency | >70% |
| Cooling | Forced Air |
| Weight | Varies by configuration |
| Input Frequency | 50/60 Hz |
| Frequency Range | 87.5 - 108 MHz |
| Dimensions | Varies by configuration |
| Input Voltage | 380-415 VAC |
To Next Page
