What to do if Nautel NX50 Transmitter shows Arc Shutback?
If your Nautel Transmitter experiences an arc shutback, it means one of the rack controller’s arc detectors has been activated. To resolve this, visually inspect the inside of the transmitter to locate the fault causing the arc detector to trigger.
How to fix Nautel NX50 Transmitter Audio Loss Shutdown?
If your Nautel Transmitter is showing an Audio Loss Shutdown, it means the modulation level is below the preset threshold for the period of time specified in the Audio Loss settings of the current preset. Check the audio inputs specified in the preset and verify there is a signal present.
Why does my Nautel NX50 Transmitter have a Brownout Reset?
A brownout reset in your Nautel Transmitter indicates that the +5 V power supply voltage was less than +4.3 V, but remained above +1.4 V. The suggested solution is to replace the control/interface PWB.
What causes a Controller Reset on a Nautel NX50?
A Controller Reset on your Nautel Transmitter means the +5 V power supply voltage was less than 1.4 V, which normally happens due to a loss of AC power. Replace the control/interface PWB to resolve this issue.
General| Brand | Nautel |
|---|---|
| Model | NX50 |
| Category | Transmitter |
| Language | English |
To Next Page
