22
Problem Cause Solution
Tool won't Jets clogged Clean out or replace jets
spray - low or Inline filter clogged Clean out or replace filter
uneven spray Jets worn Replace jets
Jets not aligned properly Re-align jets
Tool valve faulty Repair or replace valve
Quick connects or hoses restricted
Clean out or replace quick connects and/or hoses
Solution Tank
Water source turned off Turn on faucet or find other water source
not filling Float not on valve arm Reconnect float to valve arm - Adjust to proper height/level
Float valve faulty Repair or replace float valve
Water hose restricted Un-kink, clean out or replace hose
Water Pressure too high Use pressure regulator on auto-fill hose
Quick connects faulty Clean out or replace quick connects (AH101B, AH102B)
Solution tank Float too heavy/ Filled with water Replace float
overflowing Float & chain tangled Make sure float chain free & hanging properly
Float too high Adjust chain to set float at proper level
Water Pressure too high Use pressure regulator on auto-fill hose
Float valve faulty Repair or replace float valve
Chemical Jug Foot valve in Filter stuck Clean out foot valve and filter
Filling with Foot valve in Filter faulty Replace foot valve and filter (PDE100-11P)
water -
Overflowing
Water Not Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Getting Hot Temperature Switch faulty Replace Temperature Switch On Heater
Water Being used too fast Re-jet wand – Slow the flow - Take extra drying strokes
Heater Switch OFF Turn Heater Switch ON
Heater Faulty Replace Heater (NM5044)
*
: To reduce the risk of fire electrical shock or injury repairs to wiring should only be
performed by experienced service technicians.
If you are not experienced in checking electrical wiring contact your nearest authorized service
center to perform tests and repairs to wiring and switches.
• Contact your distributor for additional troubleshooting
assistance, to order parts, or for advice and assistance in
performing necessary repairs.