Technical Specifications
MX3-500 High Pressure Extractor
Height: 42-1/4”
Length: 34-3/8”
Width: 23-3/8”
Weight: 136 lbs.
Solution Tank Capacity: 12 gallon
Recovery Tank Capacity: 12 gallon
Solution Pump: Pump-Tec #207 pump with 1/2 HP Motor - 0-500 psi – 1.06 gpm
Vacuum Motors: Two AMETEK Lamb 5.7” diameter 3-Stage – tangential discharge
Can be operated in series or parallel configuration
Pump-out Pump: FloJet 120VAC 4.5 gpm
(Optional)
Power Draw: Cord #1 – 20.85Amp wide open / 13.45amp full load
Cord #2 – 5.50Amp wide open / 2.80amp full load
(Add 14.58amps to Cord #2 for units with optional 1750W Heater)
(Add 1.50amps to Cord #2 for units with optional Pump-Out Pump)
Standard Equipment
Vacuum Connection: 2” Barb or 2”Male Flash Cuff with 2” Male NPT
Vacuum Hose: 25’ X 1-1/2” with 1-1/2” cuff & 2” cuff
2” Female Flash Cuff x 1-1/2” hose adapter
Carpet Wand:
1-1/2” SS Dual Jet S-Bend Wand
– AW29
Accessory Mounting Hardware: Four 1/4-20 x 5/8” SS Screws and Washers
Pump Priming Hose: 12” x 1/4” with 1/4” male quick connect
HP Solution Hose: 25’ x 1/4” with 1/4” male & female quick connects
Power Cords: 2 – 25’ x 12gauge with male & female plug ends
Electrical: Dual Circuit Indicator
5amp Pump Circuit Breaker
Internal Component Cooling Fan
Optional Features:
1750W Heater
Auto Fill System with chemical draw:
Metering Tip Kit: 14 different tips for changing chemical dilution rate
Water Supply Hose: 50’ x 3/8” with 1/4” female quick connect &
Female garden hose fitting
Auto Pump-out System:
Pump-out Hose: 50’ x 3/4” with male & female garden hose fittings
To Next Page
Loading...
