NAVEE EasyRide 25 Pro - Page 4

03 04
EN EN
·
The A-weighted emission sound pressure level is less than 70 dB(A).
·
The mechanical vibrations transmitted by KickScooter are less than 2.5 m/s².
·
For a better riding experience, it is recommended to carry out a regular maintenance of the product.
·
Eliminate any sharp edges caused by use.
·
Accessories and any additional items which are not approved by the manufacturer shall not be used.
·
Regular maintenance of the vehicle is a factor of safety.
·
The self-tightening nuts as well as the other self-tightening fastenings may lose their eciency and that they may
need to be retightened.
·
Regularly check the tightening of the various bolted elements, in particular the wheel axles, the folding system,
the steering system and the brake shaft.
·
Do not modify or transform the vehicle, including the steering tube and sleeve, stem, folding mechanism and rear
brake.
·
Do not make any modifications that are not noted in the instructions.
·
Make sure the scooter is turned o when being transported and kept in its original packaging if possible.
·
In order to avoid accidental injuries such as electric shock and fire caused by improper use, please read the
instructions carefully before use, and keep them properly for future reference.
·
Please use this product in accordance with the instructions in the User Manual. Users are responsible for any loss
or damage arising from improper use of this product.
·
Power-o the vehicle during charging, or into a certain nonoperational mode.
·
Do not charge if the charge port or charge cable is wet. Read this manual carefully before charging.
·
Do not charge the scooter at an ambient temperature above 40°C or below 0°C.
·
Please keep a safe distance when the scooter is driving on a level/no slope road. The braking distance will
increase in wet weather.
·
The shock absorption of this product is not adjustable (if applicable).
·
The appliance is not intended for use at elevations greater than 2000 m above sea level.
·
The appliance shall be disconnected from its power source during service and when replacing parts.
·
The external flexible cable or cord of this transformer cannot be replaced; if the cord is damaged, the transformer
shall be scrapped.
·
If the external flexible cable or cord of this transformer is damaged, it shall be replaced by the manufacturer or
their service agent or a similarly qualified person in order to avoid a hazard.
·
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
·
This product contains batteries that can only be replaced by qualified technicians or after-sales service
·
This appliance contains batteries that are only replaceable by skilled persons.
·
WARNING! For the purposes of recharging the battery, only use
the detachable supply unit provided with this appliance. Do
not use a battery charger from any other product. Keep a safe
distance from the surrounding combustibles when charging,
the vehicle must be placed in a well-ventilated area.
·
WARNING! Do not use any third-party battery or battery
charger. Use only with FY0422521500E supply unit.
·
WARNING! Keep plastic covering away from children to avoid
suocation.
·
WARNING! Never use the product close to a water source.
·
WARNING! Stop using the product when damaged.
·
WARNING! As with any mechanical component, a vehicle is
subject to high stresses and wear. The various materials and
components may react dierently to wear or fatigue. If the
expected service life for a component has been exceeded, it
may break suddenly, therefore risking causing injuries to the
user. Cracks, scratches and discoloration in the areas subject
to high stresses indicate that the component has exceeded its
service life and please contact an authorized or a specialized
repairer.
Watch out for hand crush and pinch points hazards in the following positions during use:
1. Between the handlebar and the stem when installing the handlebar.
2. Openings on the wheels.
3. Between the front mudguard and the deck.
4. Between the quick release lever and the quick release lever lock, and between the folding joint and the stem
when folding or unfolding.
5. Between the mudguards and the wheels.