09 10
EN EN
Scooter Maintenance Schedule (Recommended):
Maintaining the scooter regularly can help keep the scooter neat and in good condition, avoid safety hazards,
minimize breakdowns, slow down the deterioration of the scooter, and extend the scooter's service life.
Item
Service
Object
Actions
Every
month
Every
3 months
Every
500 km/
6 months
Every
1000 km/
1 year
Every
10000 km/
3 years
Tires
Tire Tread
Wear
Check whether the tire is
cracked, deformed, worn,
etc.
√ √ √
Screws
Handlebar
Assembly
Screws
Tighten the screw that
connects the handlebar
assembly with the stem
assembly (with the
recommended torque of
3.0 ± 0.5 N·m).
√ √ √ √
Tighten the accelerator
screw (with the
recommended torque of
1.6 ± 0.1 N·m).
√ √
Tighten the brake
lever screw (with the
recommended torque of
5.5 ± 0.5 N·m).
Environmental Instructions
The scooter contains a rechargeable lithium-ion battery pack, and improper disposal of these batteries will cause
harm to the environment. Follow the steps below to remove the batteries before disposing of the scooter and
discard the batteries properly:
1. Before removing the battery, power o and drain it to the full extent. Then tear the foot pad and unscrew the
fixing bolts between the pedal and frame to open the foot pedal.
2. Unplug the battery connector, and then remove the batteries. Do not damage the battery case to avoid any risk
of injuries. Do not use the battery if it is damaged, has a strange odor, emits smoke, or gets overheated. Keep a
leaking battery away from other objects.
3. Discard the removed batteries at a professional recycling facility.
Wheels, brake pads and other vulnerable parts are worn or damaged and need to be replaced, please contact the
after-sales service in time.
To find a qualified service shop, contact us via service@navee.tech/www.naveetech.com
Item
Service
Object
Actions
Every
month
Every
3 months
Every
500 km/
6 months
Every
1000 km/
1 year
Every
10000 km/
3 years
Functions
Brake
Adjustment
Before adjusting, make sure the
scooter is turned o and not being
charged.
Tool: 5 mm hex key (the tool needs
to be prepared by the user).
When the brake is too tight, use
the tool to turn the nut on the
screw rod counterclockwise, so
as to slightly shorten the brake
cable's exposed bottom part.
When the brake is too loose, use
the tool to turn the nut on the
screw rod clockwise, so as to
slightly lengthen the brake cable's
exposed bottom part.
√ √ √
Charging
Charge the scooter at a suitable
temperature. The indicator on
the battery charger is red when
the scooter is charging, and
turns green when the scooter is
fully charged. The control panel
will show the charging status
simultaneously during charging.
√ √ √
Steering
Turn the handlebar 60° to the left
and right to make sure the turning
angle is correct and the steering
is free from resistance and
stagnation.
√ √
Important
Components
Battery
Assembly
Fully charge the scooter before
leaving it unused for a long time,
and turn it on to charge every 60
days.
√
To Next Page
Loading...
