13
EN
7. Carry
8. Charging
Note: Please always use the original charger. If damaged, please contact the manufacturer to replace.
1. Open the rubber protector plug of the charging port.
2. Plug the charger into the charging port.
3. Close the rubber protector plug after charging.
The scooter is fully charged when the LED on the charger changes
from red (charging) to green.
Hold the stem with either one hand or both hands to carry.
Warning!
· Do not touch the interface when charging, be careful of electric shock.
· Please check and make sure the power is o before charging.
· NEVER turn on the power when charging.
· Do not use this product when charging to avoid damages.
· It is recommended to only charge at temperatures between
0-45 ℃ / 32-113 ° F.
· Please keep the scooter body away from heat sources, open ames, and
ammable and/or explosive gases (pressurized and liquid states).
Charging Port
To Next Page
Loading...
