NAVEE N65 - Troubleshooting

18
EN
13. Troubleshooting
If the scooter is not working properly, the screen display will show an error message. Please refer to the
troubleshooting table below to nd your solution based on the error message.
Error Error Message Solution
E1
Rx Communication
Failure
Check whether the tail light is on, if not, replace the controller or
instrument. If it is on, please check whether the wire connection
between controller and instrument.
E2 Braking Error Check the wire connection or replace the brake level.
E3 Accelerator Error Check the wire connection or replace the accelerator.
E4 Wheel Motor Error
Check whether the wheel motor and the controller cord are well
connected or replace the motor.
E5 Controller Error Check the controller wire connection or replace the controller.
E6
Overheating Warning
Wait until the battery temperature normalizes before resuming use.
14. Certication
EU Declaration of Conformity
This device meets the EU requirements on the limitation of exposure of the general public to
electromagnetic elds by way of health protection.
Hereby, Brightway Innovation Intelligent Technology (Suzhou) Co., Ltd. declares that the radio equipment
type N65 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: http://www.mi.com/global/service/support/declaration.
html
Hereby, Brightway Innovation Intelligent Technology (Suzhou) Co., Ltd. declares that the radio
equipment type N65 is in compliance with the Radio Equipment Regulations 2017, Supply of Machinery
(Safety) Regulations 2008 and the Restriction of the Use of Certain Hazardous Substances in Electrical
and Electronic Equipment Regulations 2012. The full text of the UK declaration of conformity is available
at the following internet address: https://www.mi.com/uk/service/support/declaration.html.