The BSM-1 sounder module connects between the transducer
and display unit or via a network switch.
Before installing the BSM-1, consider location and cable runs
necessary to connect the module to the display unit and power
source.
You will need to attach the power cable, Ethernet cable and a
transducer to the BSM-1.
The transducer and Ethernet cables are not included.
Do not run the transducer cabling near the BSM-1 DC
power cables or any VHF antenna coax cables or any VHF
DC power cables.
The BSM-1 conforms to the appropriate Electromagnetic
Compatibility (EMC) standards; but proper installation is
required to get the best use and performance from this product.
To Next Page
Loading...
Need help?
General