Navien Gas Water Heater Installation
█
Specifications:
Please review these specifications before installation to confirm proper unit selection: As
Navien is dedicated to continuous product improvement, Navien reserves the right to
change specifications and/or design and/or discontinue any model or feature without
prior notice and without incurring obligations.
Min: 15,000 Btuh
Max: 150,000 Btuh
Min: 17,000 Btuh
Max: 180,000 Btuh
Min: 17,000 Btuh
Max: 199,000 Btuh
Min: 15,000 Btuh
Max: 150,000 Btuh
Min: 17,000 Btuh
Max: 180,000 Btuh
Min: 17,000 Btuh
Max: 199,000 Btuh
Indoor / Outdoor Wall-Hung
Natural Gas Supply Pressure
(from source, Min ~ Max)
Propane Gas Supply Pressure
(from source, Min ~ Max)
Natural Gas Manifold Pressure
(min-max)
Propane Gas Manifold Pressure
(min-max)
0 GPM for “A” models (no minimum flow rate requirement),
0.5 GPM for non-“A” models
Maximum Power
Consumption
Primary Heat Exchanger: Stainless Steel
Secondary Heat Exchanger: Stainless Steel
ø3” PVC, ø3” CPVC, ø3” Special Gas Vent Type BH
(Class IIA (PVC) and Class I
PVC, CPVC, Galvanized Steel, Flex Aluminum, Flex, ABS,
Flame Rod,Thermal Fuse(Overheat Cut Off device)
APS, GPS, Gas-Valve Operation Detector,
Ignition Operation Detector, Water Temperature High Limit Switch,
Exhaust Temperature High Limit Switch
Remote Controller, Plumb Easy Valve Set,
Condensate Neutralizer, Ready-Link Communication Cable