Using the access device
Configure the Access Device
The access device screen
The available connection list shows the vSpace hosts to which the device can connect.
Select a host from the list and click on the "Connect" button to start.
The "Refresh" button refreshes the available connection list.
The Options Menu
The "Options" button brings up a menu where you can view and change the access
device's settings.
Within the “Options” screen, the "Reset" button resets the access device
The "Info" button brings up a window to view the following information about the access
device:
Version: the version of firmware running on the access device
Build: The build number of the firmware running on the access device
Date: The date of the firmware running on the access device
Device Model: The model number of the access device
Loaded Schema Version: The schema version running on the access device
IP Address: The IP address the access device is configured to use
Gateway: The IP gateway the access device is configured to use
MAC Address: The MAC address of the access device
Serial Number: The serial number of the access device
Alias: The alias of the access device, defined using the vSpace admin console
To Next Page
Loading...
Need help?
General
