NCR 4072 - Installing the UPS

To Next Page

To Previous Page

Installation

NCR 4072 UPS Site Preparation, Installation, and Operation Manual S 05147374 Rev C Uncontrolled Copy

7. Reinstall the UPS front panel.

Figure 7. Reinstalling the Front Panel

8. If the UPS requires any type of transportation in the future,

disconnect the UPS internal battery connector using the above

steps in reverse order.

Installing the UPS

The following steps explain how to install the UPS. Figure 8 shows a

typical installation only. See “UPS Rear Panels” on page 22 for the rear

panel of each model.

1. If you are installing power management software, connect your

computer to the USB port or UPS communication port using the

supplied cable (see page 30).

NOTE If you need to change the factory-set defaults for the output voltage

or input voltage range, see “Voltage Configuration” on page 29 before

installing the UPS.

2. On 230V models, plug the detachable power cord into the input

connector on the UPS rear panel.