Need help?Do you have a question about the NCR 5635 and is the answer not in the manual?
Declaration for Canadian Class A digital apparatus compliance with regulations.
Contains information required to maintain the 5635 Currency Dispenser.
Intended for design engineers and service engineers maintaining the dispenser.
Manual is organised into four chapters and one appendix.
Lists other NCR publications relating to the 5635 currency dispenser.
Overview of the 5635 Spray Currency Dispenser and its modules.
Details on currency cassettes, their parts, and types.
Explains the function and components of pick modules.
Describes the spray presenter and its housed assemblies.
Details the function and components of the control board.
Details the commands and functionality of the dispenser's firmware.
Describes a successful dispense operation and its sequence.
Details methods for mounting the dispenser in a host ATM.
Specifies AC and DC power requirements and connector types.
Describes the RS232 interface connector and its pinout.
Step-by-step guide for preparing and loading currency into cassettes.
Instructions for emptying both Standard and Latch Fast purge bins.
Procedures for clearing jams within the currency dispenser.
Procedures for calibrating the dispenser, including adjustments.
Details on identifying, adjusting, and setting up currency cassettes.
Information on performing and interpreting automatic and manual diagnostic tests.
Covers pick module timing and dispenser motor drive belt tension adjustments.
Guidelines for routine cleaning and checks of dispenser components.
Recommended lubricants and procedures for dispenser lubrication.
Instructions for cleaning dispenser components with water or isopropyl alcohol.
Procedures for replacing key dispenser components like the control board.
Details on configuring RS232 comms settings and bill singularity.
Provides pin-out details for AC, RS232, and DC connectors.
Specifies the acceptable dimensions for currency dispensed.
Details on currency cassette capacity and adjustability.
Specifies the capacity of the reject bin.
Details the dispenser's Electromagnetic Compatibility specifications.
Lists the DC and AC power requirements for the dispenser.
Provides the maximum noise emission level for the dispenser.
Lists the weights of component parts of the dispenser.
Provides the overall dimensions of the dispenser.
Specifies the normal and extreme operating environmental ranges.
To Next Page
General