Maintenance Instructions
Cassette Adjustments
NCR 5635 Spray Currency Dispenser Service Manual 4-5
NCR - CONFIDENTIAL AND PROPRIETARY
Use pursuant to Company Instructions
Magnet Marking and Position
4
It is essential that the magnets are pointing in the correct
direction, therefore, each magnet has a marked end, a red dot, to
indicate which way round it should be installed in the housing.
NOTE: Square and round section magnets are interchangeable.
The following table shows the location and orientation of the four
magnets to produce the seven cassette identification codes. The
“magnet position” in the table corresponds to the numbers 1 to 4
moulded into the plastic inside the housing.
Magnet Positions
4
Note
1. X = magnet inserted, 0 = magnet not present.
Note 2.
The bar above or below the X indicates whether the magnet
should be placed in the housing with the marked end up or down
respectively.
Code A B 1234
1 not used not used
X X 00
2 not used not used
X 00X
3 not used not used
X 0X0
4 not used not used
X X X X
5 not used not used
0XX0
6 not used not used
0X0X
7 not used not used
00XX
master.bk Page 5 Wednesday, March 27, 2002 9:35 AM
To Next Page
Loading...