Journal Printer
Replenishing Paper - Graphics Printer
6-12 P77 ATM - Operator Manual
15 Press the paper feed button to wind on the paper until all slack
is taken up and the test graphic has disappeared onto the take-
up roll.
16 If nothing is printed on the paper when the print mechanism is
closed, the paper has probably been loaded incorrectly. Check
the orientation of the paper supply roll as shown in Step 8 and
repeat Steps 9 through to 15.
17 Check that the paper is not too close to one side or it may
crumple against the roll guides and cause a jam. Open the print
mechanism and slide the paper until it is centred between the
guides. Close the print mechanism, the “smiley” graphic should
be printed again.
18 Follow your in-house procedures for indicating that the journal
paper has been replaced.
19 Press the Normal/Supervisor switch, on the operator panel, to
the Normal position.
20 Close and lock the top cabinet.
Book.bk Page 12 Tuesday, July 24, 2001 9:13 AM
To Next Page
Loading...
