Getting Started
Hardware Reset
P77 ATM - Operator Manual 2-25
Hardware Reset
2
A Reset switch is provided on the operator panel. When the Reset
switch is pressed, the P77 executes its diagnostic procedures,
reloads the system software and initialises the user application
program.
To reset the P77, proceed as follows:
1 Open the top cabinet.
2 Press the Reset switch on the operator panel.
3 Close and lock the top cabinet.
Note: After the P77 is reset, several minutes will elapse before the
software is loaded and the application is displayed.
RESET
Book.bk Page 25 Tuesday, July 24, 2001 9:13 AM
To Next Page
Loading...
