Chapter 2: Installation 2-7
Powering Up
This section describes powering up the workstation and the initial
checkout procedures after all hardware has been installed.
Note: No keyboard configuration is required at installation time. The
keyboard is configured at the time of manufacture by default to
recognize the Ctrl-Alt-Del key combination for system reset.
Note: No unit setup is required at installation unless configuration
must be changed from factory defaults.
Powering up procedures is described for the keyboard when
configured with:
• PC
• 7452/53 Workstation
• 7451 & 7456 Workstations
Power Up Procedures
Plug the USB keyboard Cord into a USB port on the workstation.
1. Turn the Keylock to the Ex position.
2. Power on the workstation.
To Next Page
Loading...