NCR 7872 Series - Programming Worksheets

Chapter 3 Programming 3-3
Programming Worksheets
Protocol
14391
10
COMMUNICATIONS PROTOCOL
OCIA
NCR Long
IBM
Slot Scanner
OCIA
Non NCR
Dual Cable
OCIA
Single Cable
RS-232
Casio
Dual Cable
OCIA NCR
Dual Cable
IBM
Hand-Held
Bar Code
Reader
0
OCIA
NCR Short
(Datachecker)
IBM 1520
Bar Code
Reader
TEC
Dual Cable
1 2 3 5
6 7 A B
4
C
B053
A
B
C
D
E
0 1
Off On
Tone On/Off
Tone Frequency
(Hertz)
B
When entering Tone Frequency, the adjustment can be
incremented upward by scanning the
Hex B
tag. Each
time you scan the
Hex B
tag, the tone frequency
increases one unit. Scan the
End
tag or a valid Hex tag
to end this mode.
Tone Length
(Milliseconds)
C
When entering Tone Length, the adjustment can be
incremented upward by scanning the
Hex C
tag. Each
time you scan the
Hex C
tag, the tone length increases
one unit. Scan the
End
tag or a valid Hex tag to end
this mode.
Tone Volume
D
When entering Tone Volume, the adjustment can be
incremented upward by scanning the
Hex D
tag. Each
time you scan the
Hex D
tag, the tone Volume increases
one unit. Scan the
End
tag or a valid Hex tag to end
this mode.
Not-On-File
Tone Volume
E
When entering Not-On-File Tone Volume, the adjustment
can be incremented upward by scanning the
Hex E
tag.
Each time you scan the
Hex E
tag, the tone Volume
increases one unit. Scan the
End
tag or a valid Hex tag
to end this mode.
GOOD READ TONE
11