NCR 7895 RS232 Configuration Setup Guide Rev. B Page 9 of 12
Note: To save configuration file, click Save to PC.
10. Select scanner to load and configuration upload will start automatically.
11. Once configuration upload is completed, click Close button.
12. Close the NCR 123Scan Configuration Utility (scanner automatically reboots)
13. Remove power from the 7895 scanner then connect it to the POS with RS232
cable (replacing USB cable).
14. Supply power to the 7895 scanner device. The scanner produces three
incrementing beeps after booting up.
15. Launch any Serial application with correct com port settings then perform
tests on the 7895 scanner (ex. barcode scanning, commands sending, etc.).
To Next Page
Loading...
