2-12 Installing the N3000
Installation Procedures
Note: This section discusses the procedure for installing the NCR N3000 Site Controller
on a counter top. For other installation configurations, refer to the following
documentations:
• Wall Mount—N3000 Wall Mount Kit Instructions (1930-K000)
• Rack Mount—N3000 Rack Mount Kit Instructions (1930-K001)
To install the N3000 Site Controller, do the following:
1. Position the N3000 Site Controller on a counter top.
2. Connect the peripherals. For more information, refer to Connecting Peripherals on the
facing page.
3. Connect to a network. For more information, refer to Connecting to a Network on
page14.
4. Connect the power source. For more information, refer to Connecting to a Power
Source on page15.
To Next Page
