NCR N3000 - Connecting to a Power Source; Servicing the Site Controller

Installing the N3000 2-15
Connecting to a Power Source
The N3000 Site Controller has an external power supply of 90W rated for 110V and
240V (auto-sensing) and with a frequency of 50Hz or 60Hz. The source power is drawn
from a regular AC wall outlet.
Note: For use in locales other than North America, special wall outlet adapters or cables
are required. For international configurations, the country specific power cord may be
ordered separately.
• To connect the N3000 to a power source, connect the power supply cable to the
4-pin power DIN connector on the back panel of the N3000 and then connect the
power supply to an AC wall outlet.
Note: To avoid a possibility of electrical shock, be sure to connect the power cord to
the power supply before connecting it to the AC wall outlet.
Servicing the Site Controller
The NCR N3000 Site Controller is serviced at the feature (whole unit) level. Should the
unit require service, contact NCR support and/or Field Services using the contact details
provided in the Preface.