Chapter 3: Using the N3000
Starting Up
Note: Before starting up the N3000 Site Controller, ensure that the power supply is
connected to the AC power source. For more information, refer to Connecting to a Power
Source on page15.
To start up the N3000 Site Controller, do the following:
• Press the Soft Power Switch on the back panel of the N3000. The blue PWR status
LED (below the power switch) then lights up.
Shutting Down
To shut down the N3000 Site Controller, do the following:
• From the Windows taskbar, select Start→Shut down. The blue PWR status LED
(below the power switch) then turns off.
To Next Page
