NCR N3000 - Connecting Peripherals; Keyboard; Mouse; Monitor

Installing the N3000 2-13
Connecting Peripherals
The NCR N3000 Site Controller is compatible with standard PC peripherals. This section
discusses some of the common peripherals that can be connected to the N3000.
Keyboard
A keyboard permits users to enter data and interact with the operating system and with
the installed software.
To connect a keyboard to the N3000 Site Controller, do the following:
• Connect the keyboard to any of the USB ports on the back panel of the N3000. For
more information on the IO ports, refer to External Connectors on page6.
Note: The keyboard must have a USB interface. The N3000 Site Controller does not
support a PS/2 connection.
Mouse
A mouse permits users to interact with your operating system and installed software.
To connect a mouse to the N3000 Site Controller, do the following:
• Connect the mouse to any of the USB ports on the back panel of the N3000. For more
information on the IO ports, refer to External Connectors on page6.
Note: The mouse must have a USB interface. The N3000 Site Controller does not
support a PS/2 connection.
Note: If needed, install the appropriate mouse driver software. It the mouse
requires a custom driver, the software should come included with the mouse or
must be downloaded from the manufacturer's web site. For more information, refer
to the mouse user manual.
Monitor
A monitor is necessary to view graphics associated with most operating systems and
software.
To connect a monitor to the N3000 Site Controller, do the following:
• Connect the monitor to the Display Port or to the HDMI connector on the back
panel of the N3000. For more information on the IO ports, refer to External
Connectors on page6.