NCR SelfServ 90 - Introduction and Kit Contents; Introduction; Kit Contents

Pedestal (Dark White Color & Impact Mid Silver) 1-3
Installation Procedure
1. Determine the location of the Pedestal. Verify that this position permits access to the
AC Power Receptacle and the LAN Cable. Also, make sure that there is necessary
access and service clearance. Refer to the NCR SelfServ™ 90 (7709) Site Preparation
Guide.
2. Remove the Pedestal Base Cover by removing the screws (4) that secures it to the
base.
3. Mark the anchor holes (4) in the pedestal base on the floor. Remove the pedestal.