1-4 Pedestal (Dark White Color & Impact Mid Silver)
4. Drill the holes (4) in the floor as needed for the anchors being used.
5. Position the pedestal back in the installed location and install the four anchors. Make
sure that the anchors do not extend up above the top of the Pedestal Base more than
12.7 mm (0.5 in.).
6. Install the Pedestal Base Cover and secure it with screws(4).
7. Install the M8x16 Mounting Screws (3) on the pedestal. Do not tighten the Mounting
Screws, leave room for the kiosk cabinet to slide under the screw heads or lock-
washers. Use a 6 mm (15/64 in.) Allen Key to drive the screws.
8. Position the kiosk on top of the pedestal with the Mounting Screws (3) extending up
through the keyholes in the bottom of the kiosk cabinet. Slide the kiosk to the right.
To Next Page
Loading...
