8. Fuse replacement
If the protective fuse on the SUNCONTROL2 electronic
board is damaged, it can be replaced with the original
replacement fuse (supplied) or with a common 25A (for
SC320M) or 30A (for SC350M) automotive fuse.
Follow these steps to reach the fuse:
1. Remove SUNCONTROL2 from its housing.
2. Rotate the device to reveal the screws on the
bottom of the device.
3. Unscrew the 4 screws.
4. Remove the front shell of SUNCONTROL2 to access
the fuse.
5. Replace the fuse.
To Next Page
Loading...
Need help?
General
