To Next Page

To Previous Page

5. installation

Place the SUNCONTROL2 on the chosen surface and

secure the entire device using the ﬁxing holes

integrated in the shell with the supplied screws or

equivalent (Fig.1).

All electrical and setup connections are on the front, it

is not necessary to disassemble the plastic shells,

except for the protection fuse replacement.

On the front side, after the power connections, there's a

Dip Switch for the charging curve selection, it's

important to select the correct curve according to the

type of battery supplied, for the selection of the correct

curve please refer to the chapter "Charging curve

selection".

Fig. 1

NOTE

The optional DT002 display allows you to change parameters and

charging curves. If connected, the display will receive the

parameters set on the Dip Switch, further changes will be made

only on the display DT002.

Questions and Answers:

Need help?

Do you have a question about the NDS SUNCONTROL2 and is the answer not in the manual?

NDS SUNCONTROL2 Specifications

General