6-2 Issue 2 December 1995
Administering the INTUITY System for the NEAX Integration
Administering the Switch Link
Administration Screen
During the NEAX software installation process, the values for the Switch Link
Administration screen were administered. You need to change the default
settings on this screen. Use the following procedure to change the settings.
1. Login as craft.
2. Press to accept the AT386 default.
You see the INTUITY Administration menu as shown in Figure 6-1.
Figure 6-1. INTUITY Main Menu
3. Select Switch Interface Administration from the INTUITY Main Menu.
After you select the option, you see the Switch Interface Administration
menu as shown in Figure 6-2.
ENTER
To Next Page
Loading...
