Need help?Do you have a question about the NEC NEAX 2400 IPX and is the answer not in the manual?
Provides a general overview of the Fusion system installation.
Explains how to navigate and use the manual, including chapter structure.
Lists required manuals for Fusion system installation and prerequisites.
Outlines Fusion system advantages, service features, and telephone number usage.
Explains telephone number assignment and the use of the Centralized MAT.
Details system configurations with and without FCH cards, using Ethernet or T1 links.
Describes node types (NCN, LN, Center Node) and maximum system configuration.
Explains DM, LDM, NDM memory types and data copying procedures.
Illustrates Fusion network examples, including CCIS and Fusion link connections.
Explains how to establish tandem connections via FCCS-ACIS.
Details system configuration without FCH cards using Ethernet for Fusion link.
Details system configurations with FCH cards using T1 link, including redundancy.
Explains network conditions for designing Fusion networks, including node limits.
Covers operator calls, incoming calls (ring down), and day/night information transfer.
Provides static caution indicators and instructions for using the anti-static kit.
Explains switch settings for HUB (PA-M96), FCH (PA-FCHA), and DTI (PA-24DTR) cards.
Details the procedure for mounting HUB, FCH, and DTI cards in PIM slots.
Covers connecting DTI-FCH front cables and 10 BASE-T cables.
Summarizes data programming for new Fusion networks and CCIS upgrades.
Details assigning module accommodation data using AFMU for unique Network IDs.
Explains assigning Logical Route Numbers to external trunks using ALRTN.
Covers numbering plans and access codes using ANPDN, ASPAN, and other commands.
Details programming FCH related data, including connection route and access code assignments.
Explains Fusion Connection with 52M-SDH interface and route number assignments for FCCS/CCIS.
Describes routing Fusion trunk calls via non-Fusion trunks when Fusion trunks are busy.
Explains data assignment for CCIS services between FCCS and CCIS links.
Provides data sheets for programming commands like AFMUPL, ALRTN, ANPD, etc.
Explains checking Fusion Link status through FCH card LEDs and basic troubleshooting.
Lists Fusion-related system messages and refers to repair procedures.
Describes permanent C-level abnormal states detected by PM on FCH cards.
Explains temporary abnormal C-level program states detected by PM on FCH cards.
Details permanent PM lockup failures on FCH cards due to lost CPU diagnosis data.
Details temporary PM lockup failures on FCH cards due to lost CPU diagnosis data.
Covers messages for Fusion link (D-ch) failures and their repair procedures.
Explains FCH card faults due to ETHER controller initial failure and repair steps.
Describes recovery messages for FCH card faults, including ETHER controller issues.
Details messages for FCH status changes like initial setting or ETHER transfer failures.
Describes messages indicating an FCH card became inoperative or is make-busy.
Describes messages indicating an FCH card resumed operation or is make-idle.
To Next Page
General
