NDA-24299 CHAPTER 5
Page 61
Revision 1.0
DATA PROGRAMMING
Network Data Programming Summary
1.1.4 Fusion Link Data
• Assign the Fusion link data using the following commands:
Fusion with FCH:ACRD → ACTK → ACAN → MBCT → AFCH → AFPC → AFRT
Fusion w/o FCH:ACRD → ACTK → ACAN → MBCT → AFPC
1.2 Upgrading a CCIS Network
To install the Fusion system to an existing CCIS network, follow the overall programming procedure
below:
1.2.1 System Data
• Decide an NCN and LN on the network.
• Assign System Data for each node. Use the ASYDN command for NCN and the ASYDL command
for LN. The system data includes the size of LDM, NDM, Fusion Point Code (FPC), etc.
Note:
The data becomes effective by executing “Non-Load Initial” after setting the FPC.
• Assign unit data using the AFMU command for each node that exists on the network. Note the
AFMU command is available at NCN only.
• Assign Logical Route Numbers of all routes (external trunk) on the network using the ALRTN
command. Note that the ALRTN command is available at NCN only.
1.2.2 Numbering Plan Data
• ANPDN → ASPAN (for NCN only): Assign numbering plan data for telephone number.
• When “Operator Call” or “Priority Call (ATT)” is used on the Fusion network, replace the existing
numbering plan data for these features using the ANPDL and ASPAL commands.
Note:
The Numbering Plan data for the LDM and/or NDM cannot use separate Tenant Numbers (TN), so be sure
to assign the following data on the ASYDL command.
• ASYDL command, SYS1, INDEX 800
b1 = 1 (ASPAL command tenant data table development on LDM = Common)
b2 = 1 (ANPDL command tenant data table development on LDM = Common)
1.2.3 Station Numbering
• Assign telephone numbers using the following commands:
ALGNN → ALGSN: Assign telephone number at network level. (NCN only)
1.2.4 Fusion Link Data
• Assign the Fusion link data using the following commands:
Fusion with FCH: ACRD → ACTK → ACAN → MBCT → AFCH → AFPC → AFRT
Fusion w/o FCH: ACRD → ACTK → ACAN → MBCT → AFPC
To Next Page
Loading...
Need help?
General
