To Next Page

To Previous Page

Tools

Degauss Control: Eliminates the buildup of stray magnetic fields that

alter the correct scan of the electron beams and affect the purity of the

screen colors, focus and convergence. When activated, your screen

image will jump and waver a bit as the screen is demagnetized.

Caution: Please allow a minimum of 20 minutes to elapse

between uses of the Degauss Control.

Indicates the frequency setting of the monitor.

IPM

™

System: On: The IPM System works normally and all stages

of energy savings are utilized.

Off: The Off Mode of the IPM System is not used.

NOTE: For standard systems and graphics boards, keep the

factory setting at ON.

Selecting ALL RESET allows you to reset all OSM

™

control settings back to

the factory settings except IPM System. Individual settings can be reset

by highlighting the control to be reset and pressing the RESET button.

Controls

78131921 5/21/98, 2:25 PM7

Other manuals for NEC A Series

Questions and Answers:

Need help?

Do you have a question about the NEC A Series and is the answer not in the manual?

General