5-16
e). Operation Steps
S/N Record:
1. Connect the signal cable and S/N record. Select and run the right S/N record program, and
the dialog box appear (shown as follows), and the options setting should accord with the
figure shown as follow:
(COM: COM1; Baud Rate: 9600)
2. According to different sell region the contents is vary, there is a reference as follow Table shown:
S/N contents
Sell region The shown web address (URL) OSD select Default language
Japan WWW.NMV.CO.JP OSD Japanese
Other WWW.NECMITSUBISHI.COM OSM English
3. Key in MODEL NAME and select the right options of the dialog box. After checked ok, the foreman or the
charge should kick the “LOCK” button, the items mentioned above will be locked.
4. Scan 10 emics Barcode, kick the Enter or Send button, if shown: “Send Complete! “, means record
successfully, kick Enter or kick Send button again, then press select key make the OSD on, select the Tool
item, check the Model name, Web address (URL), OSD select and SN contents, if one of them doesn’t tally
with factual content, connect the lines compactly, record again.
To Next Page
Loading...
