DS2000 Voice Mail Setup
Installation
● Refer to your DS2000 Hardware Manual for instructions on setting
up analog ports for Voice Mail. Each Voice Mail port requires a cor-
responding analog port in your telephone system. Depending on
your installation requirements, your DS2000 system can use ASTU
PCBs or 2-OPX Modules for analog ports.
● Refer to your Voice Mail manuals for the details on connecting
Voice Mail to the DS2000 analog ports.
Telephone System Programming
1801 - Extension Circuit Type
● If you are using a 2-OPX Module (P/N 92177A only), assign circuit
type 21.
● If you are using Analog Station (ASTU) PCB ports, assign circuit
type 15.
0510 - Hunt Group Number
● Select an available UCD Hunting group (1-8) for Voice Mail.
0510 - Hunt Group Master Number
● Assign an unused extension number as the Voice Mail Hunt Group
master number. Valid numbers are 100-899, excluding the extension
and trunk number range. For example, your master number cannot
be 308 or 401.
0201 - Voice Mail Installed
● Enter Y.
0201 - Voice Mail Master Extension Number
● Enter the master number you assigned in 0510 - Hunt Group
Master Number above.
1802 - Voice Mail Port
For each analog port connected to Voice Mail, enter Y. (These are the
ports you programmed in 1801 - Extension Circuit Type above.)
1807 - Hunt Type
For each analog port connected to Voice Mail, enter 5 (for UCD).
Press VOL ▲ and VOL ▼ to verify your entry.
1807 - Hunt Master Number
For each analog port connected to Voice Mail, enter the master exten-
sion number you assigned in 0201 - Voice Mail Master Extension
Number above. Press VOL ▲ and VOL ▼ to verify your entry.
DS2000 Voice Mail Setup
Installation
● Refer to your DS2000 Hardware Manual for instructions on setting
up analog ports for Voice Mail. Each Voice Mail port requires a cor-
responding analog port in your telephone system. Depending on
your installation requirements, your DS2000 system can use ASTU
PCBs or 2-OPX Modules for analog ports.
● Refer to your Voice Mail manuals for the details on connecting
Voice Mail to the DS2000 analog ports.
Telephone System Programming
1801 - Extension Circuit Type
● If you are using a 2-OPX Module (P/N 92177A only), assign circuit
type 21.
● If you are using Analog Station (ASTU) PCB ports, assign circuit
type 15.
0510 - Hunt Group Number
● Select an available UCD Hunting group (1-8) for Voice Mail.
0510 - Hunt Group Master Number
● Assign an unused extension number as the Voice Mail Hunt Group
master number. Valid numbers are 100-899, excluding the extension
and trunk number range. For example, your master number cannot
be 308 or 401.
0201 - Voice Mail Installed
● Enter Y.
0201 - Voice Mail Master Extension Number
● Enter the master number you assigned in 0510 - Hunt Group
Master Number above.
1802 - Voice Mail Port
For each analog port connected to Voice Mail, enter Y. (These are the
ports you programmed in 1801 - Extension Circuit Type above.)
1807 - Hunt Type
For each analog port connected to Voice Mail, enter 5 (for UCD).
Press VOL ▲ and VOL ▼ to verify your entry.
1807 - Hunt Master Number
For each analog port connected to Voice Mail, enter the master exten-
sion number you assigned in 0201 - Voice Mail Master Extension
Number above. Press VOL ▲ and VOL ▼ to verify your entry.
NVM-Series instructions are on the other side. NVM-Series instructions are on the other side.
To Next Page
Need help?
General
