NEC DT330 - Boss;Secretary - Mw Lamp Control

64
Announce the call to the boss.
If Boss Accepts Call
Secretary replaces handset.
Secretary presses boss’ line to return to calling
party.
If Boss Refuses Call
Secretary presses boss’ line to return to calling
party.
BOSS/SECRETARY - MW LAMP
CONTROL
To Set MW at Boss’ Station
With caller on the line
Lift handset or press key.
Press boss’ ringing line. Ask calling party to hold.
Press the MW-SET line/feature key. No service set
tone is heard.
Boss sees MW on display and can call secretary to
receive message.
Without caller on the line
After taking message, press key and
receive dial tone.
Press the MW-SET line/feature key. Receive ser-
vice set tone.
To Cancel At Boss’ Station
With caller on the line
Lift handset or press key. Receive dial
tone.
Press Boss’ line appearance.
Press MW-CANCEL line/feature key. Receive ser-
vice set tone.
Boss and secretary station each
display the other’s numb
4:26 PM TUE 13 APR 2004
ICM XXXX
DT330/310
Speaker
Note:
The secretary can hang up after taking a mes-
sage, and set a message lamp at any time by
going off-hook on the boss’ multiline and press-
ing the MW-SET key.
4:26 PM TUE 13 APR 2004
MW SET
Recall
4:26 PM TUE 13 APR 2004
MW SET
Speaker