EasyManua.ls Logo

NEC DT400 - Call Hold and Exclusive Hold; Placing a Call on Hold; Placing a Call on Exclusive Hold; Retrieving Held Calls

NEC DT400
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To Place a call on HOLD
Press Hold. Held line wink flashes.
Held station number
HOLD 1212
4:26 PM TUE 13 APR 2020
[ Voice ][ Headset ][ Release ]
Note: If held line appears on other DT Series stations, the
associated LED flashes red slowly.
To Retrieve
… Lift handset or press Speaker key.
… Press held line. Use handset to converse.
Note: Any station with this line appearance can retrieve the call.
If Unanswered
… After preprogrammed time, Automatic Recall is initiated.
… Visual and audible signal (rapid flash and ring burst) is sent to
station that placed call on hold.
Note: Hold shows as a flashing green LED on your phone.
The same line on other phones shows as a flashing red LED.
Recall shows as a flashing green LED on your phone and flashing
red LED on other phones with the same line.
To Place a Call on Exclusive Hold
… Press Hold twice. Line appearance indicates interrupted
wink.
Held station number
E-HOLD 1212
4:26 PM TUE 13 APR 2020
[ Voice ][ Headset ][ Release ]
Note: If held line appears on other DT Series stations, LED
remains steadily lit red.
To Retrieve … Lift handset or press
Speaker.
… Press held line. Use handset to converse.
Note: Only the DT Series that set Exclusive Hold option can
retrieve the call.

Related product manuals