NEC DT700 User Guide

SIP Handset User Guide
*If you forget or lose your passcode it can be reset to the default by an administrator, please email: telephones@essex.ac.uk
ISS (Telecoms)
[Publish Date] C:\Users\dwjoll\AppData\Local\Microsoft\Windows\INetCache\Content.Outlook\76WE6Q4W\TELS 005 SIP phone 4
(DT 700) features 20180316 4.docx
SIP Handsets NEC DT700 - Features quick reference
Initialise a call
1. Receiver: lift the receiver to answer or start dialling to make a call (or to take call off speaker at any time).
2. Speaker: dial number and then press the dynamic button ‘Dial’ (bottom left when numbers inputted).
3. Speaker: press static button ‘Speaker’ then dial number.
Voicemail
Press this button to automatically dial the voicemail server. The receiver can be left in place to use the speaker whilst
doing this.
Call Transfer
1. Press the ‘Transfer’ button and wait for dial tone before dialling extension. The transfer can be completed
without the dialled extension being answered. Complete transfer by replacing the receiver or pressing the
‘Transfer’ button again.
2. If you need to retrieve the original call use dynamic buttons ‘End call’, then ‘Resume’ (bottom right of LED
screen).
Call Pick up
To use the group pick up feature dial *84 or if a speed dial button has been assigned to the extension that is ringing,
press this speed button to pick up the call (replicating *84).
5. Programmable
Buttons
(2-12 only)
7. Feature Button
8. Menu Button
9. Speaker Button
3. Hold Button
6. NewCall/EndCall
1. Voicemail
2. Exit Button
Dynamic LED screen
options such as ‘Voicemail’
‘NewCall’ are multi-
functional and toggled by
buttons outlined in the
yellow boxes to the right.
Select Wheel
Last No
Redial
Select
button
Directory
Menu
Pressing the ‘Menu’ button enables access to the following options that are
displayed on LED screen (to exit press ‘Menu’ again):
1. Personal Directory
2. Call History
3. User settings – ring tone, display brightness, clear user settings etc
4. Admin Settings (PIN protected Administrator system configuration)
5. Reboot Phone (see below for instructions)
6. Status – information is displayed
To select an option either press the corresponding number on the keypad or
navigate using the ‘Select Wheel’ and ‘Select button’.
Static buttons e.g. ‘Exit’
and ‘Menu’ have one
function and are labelled in
white print.
2. Transfer
Figure 1

NEC DT700 Specifications

General

Network Protocol	SIP
Ethernet Ports	2 (10/100/1000 Mbps)
Power over Ethernet	Yes
Speakerphone	Yes
Headset Port	Yes
Supported Codecs	G.711, G.729
HD Voice	Yes