English-23English-22
Connect To The Power Source
The display should be installed close to an easily accessible power outlet.
Fully insert the prongs into the power outlet socket. A loose connection may
cause image degradation.
When the power cord is connected, the display turns on and the front LED at
the bottom of the display lights up in red or is off.
Cable Information:
CAUTION:
Use the attached specied cables with the E657Q / E557Q / E507Q / E437Q
/ E327 color monitor so as not to interfere with radio and television reception.
Use of other cables and adapters may cause interference with radio and
television reception.
(1) Please use the supplied power cord or equivalent to ensure FCC
compliance.
(2) Please use the supplied shielded HDMI signal cable.
(3) For mini D-Sub 15-pin and USB, please use a shielded signal cable with
ferrite core.
(4) For D-sub 9-pin and Coaxial, please use a shielded signal cable.
To Next Page
Loading...