OR ➤ Use the dialpad to enter the first letter of the desired entry then dial *.
➤ Press UP/DOWN Softkeys to scroll.
➤ Lift handset or press Speaker or press an idle Outside Line key to place
call to displayed entry.
OR Press Feature or Exit or wait 10 seconds to cancel.
NOTE: For example, when using the dialpad to search the directory for the name “Ann”, dial the number
2
on the dialpad followed by the *. To search for “Bob”, dial the number 2 twice and then *. To
search for “Carol”, dial the number 2
three times and then *. To search for “Dan”, dial the
number 3
followed by *.
M
icrophone Control
➤ Press Feature.
➤ Dial MIC On/Off code 1
.
NOTE 1: Lit MIC LED indicates MIC on.
NOTE 2: MIC ON/OFF key may be assigned to a Feature Access key or One Touch key.
S
peakerphone Calls
➤ Press Speaker; LED lights.
➤ Ensure MIC LED is lit.
➤ Place internal or outside call.
➤ Converse.
➤ Press Speaker to disconnect call.
NOTE: The handset may be used at any time during the conversation. To resume handsfree operation or to
monitor a call, press Speaker (LED lights) and replace handset.
G
roup Listening
With a call in progress via the handset/headset:
➤ Press Speaker; LED lights.
➤ Converse. Conversation is heard over the speaker and handset/headset. Only the
handset/headset may be used to respond.
➤ Press Speaker to cancel Group Listening mode.
NOTE: When switching from Group Listening mode to Speakerphone mode, it is recommended that the
Microphone be turned off.
5
To Next Page
Loading...
